ITALIANO  
| The company
| Products & services
|References
| Where we are
|Contacts
|.Home.|

INDUSTRIAL ELECTRONICS

Our company designs and builds electronic circuits on specific costumers request. On the list there is a large number of circuits for general uses in the industrial area, for example: signal interfaces, interfaces with relays, displayes for voltages and currents measures, voltage/frequency converters etc… In the table below a part of our production is listed. If you don’t find what are you searching for please contact our company !
Circuits for converting  signals at 24 Vcc from  PNP to NPN and from NPN to PNP up to 8 channels. They are used for example when is necessary to interface logic equipments NPN to PLC's or other components with PNP logic.

Directly mounting on omega rails.
Not stabilized voltage supply TRM01, INPUT 240Va.c. OUTPUT 24Vcc. They are used with power supply ALM01 and ALM02 to get insulated voltages of 5V, 10V, 12V, 15V and adjustable voltages from 5V to 24V. I max 1A.They are used for the supply  various kinds of transducers if the galvanic insulation with the other circuits is required.

Directly mounting on omega rails.
Stabilized voltage supply ALM01 and ALM02  produced in this versions: 5Vcc/1A, 10Vcc/1A, 12Vcc/1A 15Vcc/1A, 24Vcc/1A.

Input voltage: 24Vcc. They are utilized to generate different values of stabilized voltages from 24Vcc. They are especially used for supplying  linear and potentiometer transducers  where  it is request a range of 0-5V or  0-10V.

Directly mounting on omega rails.
Circuit board connectors for electronic boards Euro Card size.

With accessories for mounting on omega rails.
Interface circuit with high speed relays. It is used in application where are request very low reaction times (up to 10 kHz).

Directly mounting on omega rails.
Relays circuit for high voltages, Euro Card size. Tipically used on test beds with insulation test for high voltages or dielectric rigidity test. Control of the coils at 24Vcc. Switching  voltage up to 5000V
Interface circuit with 16 relays. Control of the coils at 24Vcc PNP with led indicator of excited relays. Switching load up to  10A-250V.

Directly mounting on omega rails.
Interface circuit with 8 relays. Control of the coils at 24Vcc PNP with led indicator of excited relays. Switching load up to  10A-250V.

Directly mounting on omega rails.

 
Multiplexer circuit MUX08. It is used to save a great number of PLC inputs if the signal acquisition times aren’t critic.  Since it has 5 outputs and 8 inputs it is possible to acquire 40 inputs. On request is supplied the software routine for managing the MUX device by a PLC.

10 channels voltage to frequency converter

Input 0-10V  Output 0-10kHz,

Full scale output factory set.

Euro Card size.
Optoisolated interface, Input line-driver, Output 24Vcc PNP, 4 channels. Suitable for interfacing   line-driver encoders (or standard RS 422)  to the quick inputs of a PLC.

Frequency max.: 200kHz

Directly mounting on omega rails.

NEXT >>>>>